Lancer Register Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
955 Posts
Discussion Starter · #1 ·
Could someone tell me if E7 front shocks fit the E5? I presume that the 6's are the same but i'm not sure about the 7.
Mine are on their way out, & i have seen a set from a 7 with low miles, but not sure if they will fit.

Cheers
 

·
Registered
Joined
·
7,349 Posts
on the front.....
clamps/mounts on the lower portion of the front dampers are bigger/wider on the e7 than e5

You'll have to use a a 'sandwich plate' in between the damper mounts/clamp and the mounting point on the front hubs to get them to fit properly.
- also need use top-mounts or camber plates specific to your e5

if these are coilovers which are normally an inch shorter than oem shox.....should be ok
- ride will probably be harsher as e7 is heavier than

if they're not coil-overs.....wouldn't bother especially as you're probably not going to be able to trial-fit before buying
...look for e4 to e6-specific stuff
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top