Lancer Register Forum banner
1 - 7 of 7 Posts
G

·
Discussion Starter · #2 ·
Best way to tighten them is as follows:

1. Hand tighten all round then torque up to 55 Nm (don't know conversion to old units)
2. Put car on floor and tighten fully to 110 Nm

Hope this helps

Andy
 
G

·
Discussion Starter · #5 ·
and I always thought it was hand tight all round and then foot stamping tight :D
 
G

·
Discussion Starter · #7 ·
Sorry for the delay in saying thanks to one and all, been away.
Torque wrench here i come.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top