Lancer Register Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
666 Posts
Discussion Starter · #1 ·
hello all, what part is this so i can order one from dave or mitso please, it just broke last night but i think its my fault as one of the bolts holding it in has disapererd and i had this bolt off abit back , its on the drivers side near the wheel, so looks like the pressure of only one bolt has snapped it :cry:



many thanks
andy
 

·
Registered
Joined
·
1,633 Posts
Dont worry to much buddy, even taking that hole arm off is an easy job :)

why not put some off set caster bushes in while your there ;)
 

·
Registered
Joined
·
666 Posts
Discussion Starter · #4 ·
thanks all, iv just got the wish bone off and given dave a ring but hes not in till the morning,
the only other thing is while using my spliter iv split the rubber seal , is this part of the wish bone or can you buy just that to fit into the wish bone





thanks
andy
 

·
Registered
Joined
·
583 Posts
looks like you will need a new bracket on the rear bush and also a new balljoint. the balljoint should press out and then you need to press the new one in. not an easy job to be honest, so you'll have to get a garage/workshop to do it unless you have a press.

dunno. dave will know more - recommend you speak to him in the morning.
 

·
Registered
Joined
·
666 Posts
Discussion Starter · #6 ·
thanks mike will get them both off dave, iv got a frend with a garage who can press me one in

andy
 
1 - 6 of 6 Posts
Top