Lancer Register Forum banner

1 - 3 of 3 Posts

·
Premium Member
Joined
·
12,346 Posts
Discussion Starter · #1 ·
Noticed a slight leak from this area and assume its a paper gasket that should be replaced, anyone know where i can get one from other then mitsu?

Also is it just a case of simply undoing the two 10mm bolts and repalcing the gasket? will there be enough movement with the bolts out to clean both surfaces and fit a new gasket?

Any advice would be much appreciated,
GUM

p.s i am doing an oil change at the same time.
 

·
Registered
Joined
·
3,219 Posts
Dave at Ears sells them, not sure if that one comes separate I got one in a gasket set.

Yeah no need to remove the pipe can be done in place.

:)
 

·
Premium Member
Joined
·
12,346 Posts
Discussion Starter · #3 ·
thanks for the reply mate, will try camskill and dave at ears on monday.
 
1 - 3 of 3 Posts
Top