Lancer Register Forum banner

1 - 1 of 1 Posts

14 Posts
Discussion Starter #1
Two months ago i bought a set of titanium con rods in order to use it in my EVO VI TM project. The clearance we measured is 0,085 mm on stock and also on an HKS forged crank. The manual says that the apper value should be up to 0,055 mm, the value we measured already in stock parts.
Do you know by expierence if clearances regarding titanium rods is allowed to reach such values (0,085 mm) or it's propably a manufacture miss ?
Thanks in advance
1 - 1 of 1 Posts