Lancer Register Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
128 Posts
Discussion Starter · #1 ·
The other day my e4 engine light came on and after checking fault code which pointed to the tps I decided to replace it. I unplugged the old tps and replaced it with a new one. The went t set it up using my multimeter . Now I know I should be getting a reading of 0.535 - 0.735 but I'm getting a reading of 0.3 -0.4 before the tps clicks and drops even lower. Can anyone advice what could be the cause of this low reading
 

·
Registered
Joined
·
128 Posts
Discussion Starter · #5 ·
Problem solved :) so I turned the tps round so the plug end was facing the passenger side of the car and found the following settings within minutes
 
1 - 5 of 5 Posts
Top