Lancer Register Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1,165 Posts
Think its 114.3 x 5 for PCD and stud dia is m12x1.5mm (think its pcd you're after) also need to get the correct offset too if you looking at another set of wheels, this should be 30 -35, with a centre bore of 67.1mm.
 

·
Registered
Joined
·
47 Posts
Discussion Starter · #4 ·
Thanks for the replys, I asked because i'm selling my original 5 wheels on E-Bay, had a question asking for the diameter, assuming this guy wants to fit them to another car, does anyone know what cars the 5 wheels will/will not fit on :)
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top