Lancer Register Forum banner
1 - 7 of 7 Posts

Very Senior User
1,132 Posts
Discussion Starter · #1 · (Edited)
Have the following surplus from my recent build. All custom work by Norris Designs.

Intake manifold with welded and ported 74mm S90 adapter - £250
(It was fully cleaned ready for fitting but I decided on a different route)

Custom 3" intake pipework (2.5" from turbo to intercooler) - will polish up nicely! - £250
Includes silicone joiners and clamps.

ETS intercooler 90mm that needs new brackets welding - free for pickup only from GU10 - SOLD

ViPec V44 Evo IV-VIII plug-in ECU with CAN bus enabled mod - SOLD
(includes USB cable and knock interface with new connectors )

Geartronix "Easyshift" flatshift module with cable less than 12 months old - £250

Located Farnham, Surrey
Please message to contact. Offers welcome.
Thanks for looking.

Wood Gas Sculpture Automotive exterior Automotive wheel system

Automotive tire Gas Sculpture Engineering Auto part

Automotive exhaust Gas Auto part Metal Nut

Car Vehicle Land vehicle Hood Yellow

Circuit component Electrical wiring Gas Cable Wire


1 - 7 of 7 Posts