Lancer Register Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
1,403 Posts
Discussion Starter #1
A question that must of been asked before but i searched and all the sites posted didnt have them anymore, i want to get three gauges to slot in to the gap below my VI stereo but normal 52mm gauges dont fit in there do they?

Any help to point me in the right direction would be good

Alex
 

·
Premium Member
Jesus built my car
Joined
·
38,798 Posts
AlBoy said:
did you have to swap the stereo to the bottom one then for it all to fit?
No. It came with a double-DIN from Japan which I swapped for the single-DIN and thought the gauges would be better on top as they are easier to see there.
 

·
Registered
Joined
·
1,403 Posts
Discussion Starter #5
ok, mine has the gap at the bottom so ill have a look into changing it round, i have one gauge that a friend gave me and it didnt seem to fit, i think a complete dis assemble this weekend may sort it all out lol
 

·
Premium Member
Jesus built my car
Joined
·
38,798 Posts
One thing I did have to do was remove the plastic bezel/surround thing from the stereo cos it wouldn't fit under the dials with it in place.
 

·
Registered
Joined
·
1,403 Posts
Discussion Starter #7 (Edited)
i should have my gauge holder soon so i can have a proper look, by the time ive finished with it, it will fit lol

now for the biggest question, what gauges should i get? i use the blitz boost controller to read my boost
should i get:
oil pressure
oil temp
egt
afr
etc
etc

opinions please
 
1 - 7 of 7 Posts
Top