Lancer Register Forum banner

power fc boost display

376 Views 3 Replies 4 Participants Last post by  grale22
I have just got hold of a power fc but it wont display the boost level in monitor mode. It just sits at zero! Its on the standard solonoid.

Any ideas?
1 - 4 of 4 Posts
you need the boost control kit as the FC has no way of monitoring air pressure, the kit comes supplied with a MAP sensor to enable this.
Unfortunately there doesn't look like there is a boost control kit listed for the evo. Its back to a boost controller or a good old fashion boost gauge sorry.
That's not a bad thing though, as the boost controller for the Power FC is not particularly sophisticated and pretty much all the well known boost controller will be better at holding boost.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.