Lancer Register Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
6,448 Posts
Discussion Starter · #1 ·
Did a load of work today and one problem was spending about 20 Min's on a rivet, trying to unscrew it only to have it F**king snap on me :wallbang::wallbang:

I know if I can get to the back of it you can use a screwdriver to push the thread down and then unscrew it. Bit what do you do about the ones you cannot get to the back off. Just snap them and replace???

Also anyone know a supplier of these. Not even gonna bother asking :Mitzi:. don't fancy :moon: just for some plastic

cheers:smthumbup
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top