Lancer Register Forum banner

1 - 20 of 26 Posts

·
Registered
Joined
·
2,522 Posts
Discussion Starter · #1 ·
Well here goes, I have recently fitted a few new parts and it was time to get it mapped so where else would I go:D

I have to say a top job and a big thanks to Matt @ TRL for his hard work:smthumbup

I had a few reservations about what to expect but we :rolleyes: (Matt) got there in the end:smthumbup

Mods are:

Crower 272 cams (standard springs/retainers for now)
Ball bearing converted and modified MR turbo (Thanks Willox)
aps induction and 4 inch intake pipe (thanks Parksy)
uprated fuel pump
AMS intercooler/hardpipe
Full race manifold:naughty:
EcuTek
Hks boost controler
3 inch magnex
Before any mapping started the pre-run;)

Then the after runs and air/fuel ratio's

I'll try and get a pic up of the full race manifold at full throttle:coolsm:
 

Attachments

·
Registered
Joined
·
2,522 Posts
Discussion Starter · #4 ·
Thanks guys, I was a bit concerened that I might have got valve float but no need to worry in the end:coolsm:
 

·
Registered
Joined
·
2,522 Posts
Discussion Starter · #6 ·
The worst bit was seeing other Evo's there in a higher state of tune than mine. . . makes you want to spend more money:wallbang::goingmad:

Cheers Wes
 

·
Registered
Joined
·
2,522 Posts
Discussion Starter · #11 ·
Cheers guys I was suprised it made that much power on only 1.6 bar:smthumbup
 

·
Registered
Joined
·
2,048 Posts
Nice results mate :D

How much help do you think the Crower cams gave you?
 
1 - 20 of 26 Posts
Top