Lancer Register Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
571 Posts
Got a milltek sports cat downpipe and system ,the two bolts i think your talking about I removed from underneath the car with a long extension bar and a U/J joint 3/8 drive, if I remember?Was a couple of years ago!
 

·
Premium Member
Joined
·
27 Posts
Discussion Starter · #3 · (Edited)
Do you remember removing X-brace underneath the car? Think we are talking about the same bolts. Two that would go on the left side in this picture,where donut gasket should be used:


I could possibly access one of the nuts, but how did you get to bolts, to stop them from spinning?
 

·
Registered
Joined
·
571 Posts
The bolts i,m thinking of were flanged head bolts with the springs behind them,no nuts as what ever they came out of was threaded if that helps?
 
1 - 4 of 4 Posts
Top