Lancer Register Forum banner
1 - 18 of 18 Posts

·
senior stroker
Joined
·
2,310 Posts
eric
when i got my rc engine done they advised me to get the hks spark amplifier thing

as it was missing on full boost

that was when i first got it back about 450-500 horse

steve
 

·
Registered
Joined
·
3,154 Posts
600
 

·
Registered
Joined
·
5,960 Posts
the stock coil pack can handle up to 650
 

·
Premium Member
Joined
·
2,442 Posts
Discussion Starter · #6 ·
Thanks guys, I am running about 600hp, 2.4 bar boost & I think it it missing at high boost. I have tried new plugs, but still it misses. I will be fitting a new CNC head in the coming months, so I may aswell go for the uprated coil packs.

Any suggestions on which pack to buy

Eck
 

·
Registered
Joined
·
3,436 Posts
Have you tred lessening the spark plug gap a little before spending your money. That alot of boost to blow out the spark ?
 

·
Registered
Joined
·
3,436 Posts
Chris, I set the gap at .06 I think, should I try and close it a bit more.

Eck
Yes mate , try .55 first and then .5 if that doesnt help. I would go any lower than .5 though.

Incidentally , what plugs are they ??? The iridium ones definatley have a short life span and give up with no obvious clues looking at them. NGK BPR8ES at a couple of quid a go and change them more often.
 

·
Registered
Joined
·
1,361 Posts
PM Sent Eck.
 

·
Registered
Joined
·
3,154 Posts
2.6 bar and you'll be blowing spark.

reduce boost or get something like sparktech cop.
 
1 - 18 of 18 Posts
Top