Lancer Register Forum banner
1 - 10 of 10 Posts
G

·
Discussion Starter · #1 ·
Hi,

A stock E6 looks too jacked up at the front. Can I lower just the front end as the back looks fine, or would this upset the car in terms of geometry/handling etc.
 
G

·
Discussion Starter · #3 ·
THe aftermarket lowering springs drop the front more than the back. From memory, I think the Eibachs that Ralliart use drop the front 20mm, then back 10mm.
 
G

·
Discussion Starter · #5 ·
Mmm - different springs drop them different heights. I think you are quoting the HKS springs... though the Eibachs were not as low.
 
G

·
Discussion Starter · #7 ·
I've been running the Leda lowering springs for a couple of months now - 40mm front/20mm rear drop. Slight handling improvement and closes up the front wheelarch gap nicely without making the rears disappear into the arches.

Steve.
 
G

·
Discussion Starter · #9 ·
Yep, fück lowering springs. The front wheelarch on an Evo 6 looks very big compared to the rear but to alter that difference for aesthetic reasons is not very smart as the car looses its balance.
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top