Lancer Register Forum banner
1 - 7 of 7 Posts
G

·
Discussion Starter · #1 ·
to change the brake hoses for the goodridge ones it's a pain in the arse to remove the standard ones

does someone has a nice tip to do this properly

regards

andre
 
G

·
Discussion Starter · #4 ·
Andre,
We make braided brake lines , tell me yr difficulty and I will sort it 4 u.
 
G

·
Discussion Starter · #5 ·
Evoboy

it's not the new hoses
it's the little (bolt) to loosen original hose from metal hose those things are so hard to loosen mostly you wreck it
i hope you know what i mean my technical english is far from good.http://www.ltregister.f9.co.uk/graphics/happy1.gif border|EQU| 0 align|EQU| absmiddle >

regards

andre
 
G

·
Discussion Starter · #6 ·
I know what you mean advevo. To do the job properly you really need a special brake spanner that just slots through the brake pipe and then drops down on the nut and grips it more firmly than an open ended spanner. I ended up using mole grips (I can hear the wince from Evoboy now
 
G

·
Discussion Starter · #7 ·
Andre,
U need a Flare nut spanner , and I think the size is 11mm ,I'll double check and let u know.Maybe u have a Snap-On tool dealer over there , if not then Facom or Stahlwille are also good.
Usually without the correct tool the various nuts are damaged.
H,
U butcher
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top