Lancer Register Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
2,041 Posts
Discussion Starter · #1 ·
HELP

Just went out

Put my foot down, boost, small pop, then no boost

Thought a hose had come off, no boost at all on gauge

Cannot see any lose hoses

Could the diaphram on the actuator go?

What things can I check to isolate the problem

A 2.0 normally asperated is boring
 

· Registered
Joined
·
8,984 Posts
Hi Fatman.

Sounds like a pipe to me, check them all out again.

If the actuator goes, you normally get boost, albeit not very well controlled and either loads or about .8 bar.

The other option is, the turbo has seized :( Take the inlet pipe off and see if it looks ok and can be spun by hand?
 

· Registered
Joined
·
2,041 Posts
Discussion Starter · #3 ·
Weebl said:
Hi Fatman.

Sounds like a pipe to me, check them all out again.

If the actuator goes, you normally get boost, albeit not very well controlled and either loads or about .8 bar.

The other option is, the turbo has seized :( Take the inlet pipe off and see if it looks ok and can be spun by hand?
Chears M8

Your right the Intercooler silicon has come off on the inlet side, how the heck do I get at this ?
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top