Lancer Register Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
241 Posts
Discussion Starter · #1 ·
OK got home from work tonight and got water leaking from back of engine.

After alot of cursing and knuckle scraping have tracked it down to the metal pipe about an inch diameter which runs along the back of the engine under the inlet manifold. It runs from the thermostat housing to opposite end of engine (the bottom heater hose connects into this).

Anyway this metal pipe has a pinhole in it (unbeleavable eh?)

Question is how do I remove this?

To me it looks like it would be easier to remove the entire inlet manifold to get access to it.

Any advice????

Steve.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top