Lancer Register Forum banner
1 - 20 of 22 Posts

·
Registered
Joined
·
1,797 Posts
Discussion Starter · #7 ·
just had a reply :smthumbup
Hello Steve,

Below 30k miles we'll use 85mm pistons , 30k + we'll use between 85.5mm or 86mm pistons.

All core work is also done sir
 

·
Registered
Joined
·
9,312 Posts
NR Autosport
MA Developments
Pete Whitfield

I would be going to one of those for a forge, not ebay.
 

·
Registered
Joined
·
1,797 Posts
Discussion Starter · #15 ·
Mate, there are enough traders on here who will do a forge job without going to an unknown off ebay.
not going to get it done just came across it the other nite. would love to run abit more power :D just dont no which way to go:confused: do i get a drop in kit done!!!! will see how prices work out:smthumbup
 

·
Registered
Joined
·
9,312 Posts
mark did my forge mate, its spot on :)

doesnt use a drop of oil above normal either :)
 

·
Registered
Joined
·
11,325 Posts
cheers raj will drop mark a pm :smthumbup
if you are down there tomorrow I'll see you ... if it's dry I'll be getting mine mapped after the new cams went in

his pm address on the MLR is "madevelopments"
 

·
Registered
Joined
·
9,312 Posts
new numbers tomorrow then Raj?? :D

come on sunshine, you should be where i am :) with earlier spool to boot!
 

·
Registered
Joined
·
1,584 Posts
contacted this company and and they offered to forge my engine for about £1600 wtf could barely do it for that if you were doing it yourself ,say they have built loads of evo +scooby forged engines anyone ever used them
 
1 - 20 of 22 Posts
Top