Lancer Register Forum banner

1 - 5 of 5 Posts

Premium Member
Joined
339 Posts
Discussion Starter · #1 ·
Hi folks I need another piece of advice please, I am changing the off side wheel bearing this morning but have had to totaly remove the Hub as one of the bolts is stuck beyond stuck, while removing the Hub I have managed to pull the drive shaft an inch or two out of the box, is it just case of giving it a little wiggle and push and it will pop back in?

Thanks in advance 馃憤
 

Premium Member
Joined
339 Posts
Discussion Starter · #3 ·
Brilliant thanks stu, it's now popped back in, now got to put it all back together replace the abs sensor I managed to break then it's on to the rear drop links.
 

Premium Member
Joined
339 Posts
Discussion Starter · #5 ·
good luck getting the sensor out :blah::lol:

Stu
lol that was a bstard ended up having to drill most of it out.

Still have a horrible judder/vibration though need more investigation 😡
 
1 - 5 of 5 Posts
Top