Lancer Register Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
9,716 Posts
nigel708 said:
got it all unbolted but can't get the trans box off :confused:
Did you look at RichW's site?

You need to pop the output shafts out. Screw something into the end of one, wedge something behind it then smack it with a hammer (outwards) it should pop out. Long rod through the box to pop the other out.
 

·
Registered
Joined
·
11,140 Posts
Re: Re: fitting new clutch

Weebl said:
Long rod through the box to pop the other out.
you can only do that if its an lsd diff, and you dont need to anyhow, just the one between the g/box and transfer box needs removing ;)
 

·
Registered
Joined
·
9,716 Posts
Re: Re: Re: fitting new clutch

you can only do that if its an lsd diff, and you dont need to anyhow, just the one between the g/box and transfer box needs removing ;)
Aye, but because of the room it is easier to remove the drivers side one first then knock out the one you need to :) Thats what i found anyway :shrug:
 

·
Registered
Joined
·
11,140 Posts
Re: Re: Re: Re: fitting new clutch

Weebl said:
Aye, but because of the room it is easier to remove the drivers side one first then knock out the one you need to :) Thats what i found anyway :shrug:
you dont have the right tools :D

and what you do have are small apparently :crackup:
 

·
Registered
Joined
·
9 Posts
Discussion Starter #8
thanks lads got it fitted now need to try it out and make sure it works again , clutch plate was sherreded and presure plate welded to bearin so was completely shot :crackup:
 

·
Registered
Joined
·
9 Posts
Discussion Starter #9
every thin fine for first 10 mile now got noisie gearbox so completely nackerd got to get it rebuild on it :confused:






drive it like you stole it :angel:
 
1 - 9 of 9 Posts
Top