Lancer Register Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter · #1 ·
Hi just fitted new friction plates and floater plate on and exedy twin plate hd and when car is started it will drive but as soon as foot is pressed on clutch the springs on the pressure plate pop out the wrong way and no drive. It's like there is too much movement on the slave cylinder. Has any one seen this before
 

·
Registered
Joined
·
3,871 Posts
dont know about this issue but i have a twin plate hd exceedy and i made a adjustable bracket to stop the slave cylinder going to far as all the travel is not needed , so basically it doesnt over travel now and as it wears it can be adjusted
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top