Lancer Register Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
164 Posts
Discussion Starter · #1 · (Edited)
hello,i have evo6 tme with stage2 mod.filter. :confused: :flame: :hammer: decat exh.pump.fuel regulator.Apexi,s p.f.c.with boost control kit and map by [email protected] [email protected] bar.so i went for rolling [email protected]lt are :1st run [email protected] 6670rpm-331bhp [email protected] ft of torque.what my question is .the bhp&torque figure is about the same ??co's the torque normally lower than bhp i think.(for the mod i have) :rolleyes: and they can't hit 1.4bar on the roller they can only manage hit 1.35bar.question 2 what shot of bhp from that 0.5bar.and after the rolling road seccion.i drive my car back home with my mate .on motor way it hit 1.42bar ease.then the next day i hit 1.46bar.question3. second run are still 1.35bar @361bhp .No clutch slip.the guy said the power graph on second run go up then down so it not accurated.on that day i want to ask the guy to run a .but i did't so it really is waste money :cry: :blah:
 
1 - 1 of 1 Posts
Top