Lancer Register Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter · #6 ·
Im unsure of the height of the stock one,
but most people use a 1.2 mm steel one when replacing.

Pm paulstevo on here i think he has a stock evo1 head gasket in his possesion,perhaps he can measure it for you.
Many thanks mate, I have checked my compression and it was 9:1, so I think I have stock headgasket.
And can anyone tell me what will be good air/fuel ratio at high revs with 1.1 bar boost. I think 11 is good, am I right?
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top