Lancer Register Forum banner

1 - 2 of 2 Posts

·
Premium Member
Joined
·
544 Posts
Discussion Starter · #1 ·
Hi all,

A mate of mine has recently bought an Evo 8 and wants to swap the standard manifold over to a tubular but the bolts holding the manifold onto the block seem a little rusty.

What method would folks recommend to get these off without snapping anything and causing bigger issues?

Thanks in advance

:smthumbup
 

·
Premium Member
Joined
·
779 Posts
Heat and penetrating fluid should do it. GT85 is quite good, if you want to be cautious start soaking them daily for a few days to a week before you have a go at removal. On the day of removal heat each one with a blow torch for a bit before trying to turn it - if that doesn't do it, it was probably going to snap regardless :lol:
 
1 - 2 of 2 Posts
Top