[Khanyboy31]

Hi everyone

I am restoring my evo 5, its a desirable colour so going to slowly do a resto on it. I am looking for some parts, and wondered if anyone could help please:

1. Where can I get rear and front bushes from to replace the whole lot oem preferably don't want to go for pollybush, as all suspension components are being sand blasted and powder coated so i assume it would be best to replace the rubbers.

2. Fuel filler neck pipe

3. Sump

4. New wheel bearings

5. Coilovers, as suspensions is crusty. Dont know which ones to go for, have been told stick to Tein as they are close to oem ride.

6. Don't know which discs or pads I should go for car is running standard power but aim to get it to 350ish.

7. Timing belt kit with balancer delete, as told it would be best to do this

8. Engine service kit

9. Ayc rebuild kit as ayc light is on.

10. Good condition front and rear brake disc covers/protection backing plates.

Any help or suggestions would be greatly appreciated.


Sent from my SM-G981B using Tapatalk

 

[Tim M]

We are doing something similar - our thread:

1998 Evolution V: "The Classroom"

Believe Mark Twain said something like "Don't let the classroom get in the way of learning". This project takes a pointer from that advice... We purchased a 1998 Mitsubishi Evolution V GSR, (JDM model) to educate my young assistant on how to plan, execute, and reap the fruits of one's labor as...

www.lancerregister.com

Also, purchased many parts from Amayama and Rossport. We bought OEM for most...available quite reasonable and fit like OEM. New front arms came equipped with all bushings/ball joint installed.

Other parts we went aftermarket when it was an reasonable improvement.

Good luck - it is a fun ride for us!

 

[ragz]

I might have some brake disc covers that have been epoxy coated black after phosphated

 

[ragz]

Also a filler neck pipe with same treatment