Lancer Register Forum banner
1 - 1 of 1 Posts

· Registered
24 Posts
Discussion Starter · #1 ·
Hi all,

Need some help. There are many threads similar to this but none seem to get to the point.

Not long had my evo 4 & today set up apexi boost controller with a mate who knows how. Set low boost (at 1 bar) without any problems. When we tried to set up the high boost, at around 1.2 bar a fuel cut or miss or something could be felt. If. You kept the power down it would continue fine after the miss then miss again after a while at higher revs.

What could this be?

I put new plugs and magnocore leads on the car. Could it be to do with this?

Look forward to any responses, many thanks.

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.