Lancer Register Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
3,219 Posts
Discussion Starter · #1 ·
The AC belt on my III runs over a pulley on the way to the pump, to me it looks like a tensioner pulley. Is this the case? As there is play in it and it chrips when at idle, and I was wondering how easy it is to change.

Cheers
 

·
Premium Member
Joined
·
16,914 Posts
Kenny,
Yes its a tensioner pulley, i changed the bearing in mine as it had some play in it and was making a nasty noise. Just let tension off belt and remove bracket ( 3 bolts) then you can get pulley off and change the bearing easy job :).

Cheers
Ian

p.s Pads will be in stock this week, i will let you know.
 

·
Registered
Joined
·
3,219 Posts
Discussion Starter · #3 ·
thetyrant said:
p.s Pads will be in stock this week, i will let you know.
:cool: Cheers mate, needing em ASAP as my front disks are so bad they have helped kill a wheel bearing. Got new disks just waiting on pads
 

·
Premium Member
Joined
·
16,914 Posts
No probs i will let you know the minute there ready for despatch, pm me your address and let me know how you want to pay etc.

I got bearing from a local motor factors, theres a number stampted on bearing and i just took it in and matched it up, let me know if you have trouble i could get you one and send it up but i would need the number off yours.

Cheers
Ian
 

·
Registered
Joined
·
3,219 Posts
Discussion Starter · #6 ·
Cheers mate, I'll get round to looking at the pulley when I do the brakes.

PM sent :)
 
1 - 6 of 6 Posts
Top