Lancer Register Forum banner
1 - 4 of 4 Posts

Discussion Starter · #1 ·
I need to upgrade my ecu to take 1.8bar,
I've heard that I might be able to fit an e6 ecu into an e4.
To do this i've been told that I need put an e6 airflow meter
in as well. If this possible then I would be able to have PE
re-map the ecu to my car!
advice please!!


Discussion Starter · #2 ·
You would need E6 injectors too I believe.

If you have an RS, as opposed to GSR, I have an E6 ECU, injectors, fuel rail, fuel reg and brand new air flow meter available!

ECU is ALSO remapped by PE, will support up to 2 bar (you need a boost controller too -I have a blitz available as well).

Let me know if u are interested.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.