Lancer Register Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
135 Posts
Discussion Starter · #1 · (Edited)
Just wondered if when anyone else has ordered a new crank bolt from mitsubishi or ross sport if they get one without being able to put a breaker bar in the end.

Just building my engine and it came in useful when coming to undo it that I could put the breaker bar in and no I won't have this option if i strip it down again. Can take a pic if needed

1 more quick question iv done a search and people tend to use different methods. On tightening the crank bolt the factory manual says to put some oil on it and other people tend to put a drop of lock tight on then tighten it. From experience what do you guys recommend

Thanks
 

·
BAD BISH
Joined
·
762 Posts
Yes, I got the same with washer from rosssport
 

·
Registered
Joined
·
135 Posts
Discussion Starter · #4 ·
I take it you can't get them any more then. Never mind, thanks for the reply though. Did you use oil or lock tight when you torqued the bolt up
 

·
Registered
Joined
·
135 Posts
Discussion Starter · #6 ·
Looks ace mate. Just been looking at that arp one this afternoon on the net and might get that :thumbup:
 

·
BAD BISH
Joined
·
762 Posts
Thanks!

go get one mate :smthumbup
Why not overkill? :mhihi:
 
1 - 9 of 9 Posts
Top