Lancer Register Forum banner

1 - 5 of 5 Posts
G

·
Discussion Starter #1
There seems to be a great deal of debate about where to connect a boost gague. Can someone please advise where the correct place is.
 
G

·
Discussion Starter #2
Hello T1000
The correct place for a feed for a boost gauge is from the rubber pipe that comes off the plenum chamber/inlet manifold, that runs to the bypass valve/dump valve.Its the grey pipe thats about 4-5 inches long.If you take a feed off there you won`t go wrong. Good luck. Regards, SIMON.
 
G

·
Discussion Starter #3
the information given in the above post is correct in every detail,

and yes it DOES matter,despite what you read on here.
 
G

·
Discussion Starter #4
i have T'd off the left hand side ( when you are facing the engine )of the inlet manifold. gray pipe on it is own. the pipe had been wrapped by a black tape you can easily recognise it :)

sam
 
G

·
Discussion Starter #5
hi
i have just checked mine is connected to the pipe connecting the fuel pressure regulator

sam
 
1 - 5 of 5 Posts
Top