Lancer Register Forum banner
1 - 3 of 3 Posts
G

·
Discussion Starter · #1 ·
Just got HKS 272/272 intake/exhaust cams. Is it safe to use my original valvesprings with these cams, as long as I don't raise the revlimit above stock?

I've been told that it should be safe. However, I've also been warned of potential valve float, given the higher lift profile of the cams. If I keep the revs at the stock 7000 RPM limit will this still be a problem?

Any inputs would be much appreciated!

Cheers!
 
G

·
Discussion Starter · #2 ·
Re:Can I use stock valve springs with u

no you cannot
higher lift,chances std springs becoming coilebound etc
they are cheap........just do it properly !
 
G

·
Discussion Starter · #3 ·
Re:Can I usestoc valve springs with uprated cams?

hks do a good set for there cams also jun , try to get titanium caps and do not for get vernier pulleys best of luck regards EVO400
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top