Lancer Register Forum banner
1 - 4 of 4 Posts

Discussion Starter · #1 ·
I have recently changed my tyres with new SO3's since my last set of tyres was badly worn
on the inner edges (just over an inch wide). The rest of the tyre surface was within limits with
some evidence of hard driving on the outer edges. Occasionally I drive the car hard but I wouldn't
expect the inner edge of the tyres to be that badly worn. I suspect a bad camber adjustment.

Does anybody know what are the standard Camber (front and rear if applicable) settings on
a EVO VI TME. What possible adjustments can be done to increase the life of the tyres and
what others in order to improve the handling (with everything standard, suspensionetc).

Any suggestions are very welcome.


1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.