Lancer Register Forum banner

1 - 2 of 2 Posts
G

·
Discussion Starter · #1 ·
I am reading about the squealing on the Evos and it is very depressing. I am planning to install the full Brembo kit on a Mitsubishi Cyborg which is to be rallied.

1. What front discs should I get to replace the original Brembo discs and which pads should I use.
2. Does anyone have any advice on the brake conversion/installation?

Thanks.

Mally.
 
G

·
Discussion Starter · #2 ·
I would use AP two piece discs with grooved rotors not drilled as these suffer from uneven wear , along with PFC 97 compound pads they are expensive but the stopping power is incredible !!!

I have this set up on my E6 which after completing 125 track miles at Donno showed very little wear. :)
 
1 - 2 of 2 Posts
Top