Lancer Register Forum banner
1 - 5 of 5 Posts
G

·
Discussion Starter · #3 ·
As far as the caliper retaining bolts are concerned I always use the hard but not very hard
torque settings.
 
G

·
Discussion Starter · #4 ·
...or you could refer to the dodgy main dealer mechanics all-purpose technical manual:

Tighten until thread strips. Then back off 1/4 turn .
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top