Lancer Register Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,826 Posts
Discussion Starter · #1 ·
Anyone else experienced this?

I took off the MAS and fitted an old oil filter in it's place, then added the air line until about 1 bar.
After a lot of searching I think it's the gasket on the inlet manifold/throttle body.

Will a new one fix this, or is there such a thing as an uprated one?

Ohh and if you try this yourself make sure you scure the oil filter tight - it really does go with a bang at 1 bar :D
 

·
Registered
Joined
·
11,140 Posts
i have made up a system to pressurise all the inlet pipework, had them up to 2 bar ;) i have noticed a leak at the actual butterfly for the throttle before, so give that a wiggle and see.

but to be honest, the leak is so minimal i doubt any probs will occur from it :)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top