Lancer Register Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
89 Posts
Discussion Starter · #1 ·
Hi,

I'm putting in a Gizzmo MBC and was wondering how people have been getting the boost pipe to the solenoid? Car's an Evo 5.

There's a small hole at the top left of the bay which is used already for a amplifier wiring kit positive cable and the boost gauge wiring (its a plasma gauge)

I want to drill as little as possibe and in a place that will not risk damaging anything.

Any suggestions appreciated.

Thanks!
 

·
Regional Organiser
Joined
·
3,254 Posts
Where abouts in the car are you trying to mount the controller mate?
 

·
Registered
Joined
·
1,565 Posts
I put mine through a bolt hole in the drivers side inner wing and then into the cabin from there through a wiring grommet, comes in just over the accelorator pedal. All behind the plastic arch liner outside.
 

·
Registered
Joined
·
89 Posts
Discussion Starter · #4 ·
I'm putting the controller above the stereo in the centre of the dash in the top half of the double din slot.

I was looking for the best place to drill, or any hidden grommets I havent found like Graham182's suggestion above.

Thanks!
 

·
Registered
Joined
·
8,894 Posts
I tried this Lee when i fitted mine and there was no gromet under the arch liner.So had to fit it through main loom gromet.. Is it only on driverside?
 
1 - 9 of 9 Posts
Top