Lancer Register Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
hi guys...
I have just fitted an aoexi avc-r to my evo VI....
I'm having some trouble setting it up,i wanted to set it too 1.25bar and let it self learn,though since doing this it has started to fuel cut sometimes!!!!!!!
Since then i have turned boost level down to 1bar and let it self learn... Now it peaks at 1.2 bar in 3rd and 4th gears which is fine,just what i want! But it only peaks at 1bar in 2nd and 3rd gears,my settings are as follows

boost set-1bar
duty cycle-3,000rpm-51%
4k-51%
4.5k-52%
5k-47%
5.5k-37%
6k-35%
F/B 1st-5 2nd-5 3rd-3 4th-3 5th-3

Start duty
1=0
2=5
3=12
4=6
5=10


The duty cycles were 'self learned' by the unit, if i increase the boost level or duty cycle(to up boost level in 2nd and 3rd gears it just starts to fuel cut in 5th gear!

I have now turned gear learn off in all 5 gears!!!!

If anyone can help me further,or can give me any better settings please reply!!!!!!

Thanks!!!!!!!!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top