i would like some advise on what strength spring would be best to use in a forge actuator, the car (evo 6) only has a filter and decat at the moment but im looking at getting it re-mapped at a later date with a gizzmo boost controller,
would it be better fitting a softer spring now then changing to a stiffer spring just before the re-map
cheers gray, there is a green spring (5-10 psi) fitted in the actuator and i got a yellow one (9-15 psi) as well, would the yellow one be ok now and after the re-map or would it pay me to get the stronger blue one (14-18 psi)
cheers gray, i will fit the yellow spring in tomorrow as that is enough boost until i get it re-mapped,
can i leave that spring in thou after the re-map and be able to run about 1.5 bar with a boost controller
thanks for the advise gray its much appreciated :smthumbup
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Lancer Register Forum
5.7M posts
86.4K members
Since 1999
A forum community dedicated to Mitsubishi Lancer owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!