Lancer Register Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-18 of 31 Results
  1. Wanted
    As per the title. Please pm me with what you have. The cheaper the better. Putting new bearings in the engine and thought it would be an opportunity to OEM+. Thank you.
  2. Private Sales - Parts
    For sale: - Evo 9 Mivec Engine (was told 22k road miles only) [SOLD] - Evo 9 Turbo (one days use only) [Sold] - Evo 9 Turbo (sold as seen) [SOLD] Located West Yorkshire and best offer secures.
  3. Private Sales - Parts
    All prices are collected from Leeds, West Yorkshire. Make me an offer. Block cradle Flywheel Standard short engine, used but good Complete head with cams, Mivec pulleys, some pipes and thermostat housing etc Trigger wheel, front pulley, starter motor, cam cover, timing chain case Oil pump...
  4. Private Sales - Parts
    SOLD Evo X engine, complete without ancillaries. Supplied, built, installed and mapped by Tim at Race Developments. Using a new, later block (with the :mitsi: modified lubrication) Parts cryogenically treated before assembly. With mapping time and one wet track day it has done approximately...
  5. Wanted
    Dose anyone know where there is a engine for sale. Car. MR FQ320 EVO VIII need a new engine.
  6. Engine / Turbo
    Hi! Just had the bad news that my EVO X 330SST engine needs to be replaced (bottom end failure). Would anyone be interested in my 'old' engine for parts? It has done 60,000 miles and has always been well looked after. Let me know if you think you (or someone else) maybe interested. Cheers Steve
  7. Wanted
    Hi I have a lancer gs3 with a siezed engine I have searched high and low for a replacement engine and had no look. Time is an issue now as I have a new baby and not much spare time on my hands to replace with a different one. If anyone can help it would be great. I have been offered £500 for...
  8. Private Sales - Parts
    Hi everyone. I have some leftover bushes which I won't use in the future and up for grabs. I have some front lower arm rear bushes, OEM Mitsubishi part, rose joint variant, MR519675. New and never used, but not in original packaging. I'm after 70GBP for a pair delivered. (its over 50 per piece...
  9. Wanted
    Hi everyone. I'm after the following bits. Kelford 272s Adjustable cam pulleys (no ebay special please) New or near new oil pump Fluidamper Injectors around 1000cc EVO9 oil cooler B8 Bilsteins front and rear Eibach or Spec-R springs EVO9 sump Any bottom end EVO5 upwards, mainly block and...
  10. Technical Questions
    Hi all Had my evo just stop on me made a wine and clunk nearly cut out. Now engine starts but if I select gear and draw clucth up to bite the car dips as if engaging but then just cuts out. I can't roll it / push it either its like brakes are on Any ideas??? Or any idea to even get it rolling...
  11. Private Sales - Parts
    I have 1 (NOT WORKING) Engine for sale. Reason for sale: Did have dropped valves and smashed piston. The pistons have been replaced(Stock) and the cylinder head rebuilt. However, water gets into the cylinders from somewhere. It will fire up and run with no water running through it, may be as...
  12. Wanted
    Hi, After the little grey tank that mounts on the back of the inlet manifold bracket (4g63 evo 6) I believe its a vacuum tank?!?!? It has two points to attach vacuum hoses to the top marked 'A' and 'B' and only lets air flow one way. I hope thats an accurate description? Unless someone...
  13. Lancer Chat
    Good morning everyone. I'm wondering if anyone has any insight into wet weight of the whole engine, gearbox & transmission (inc. drive shafts, diffs etc)? I.e. how much lighter would a road going Evo X be if it had nothing involved in making it move? I've tried to search but weight is an...
  14. Wanted
    Hi all .... me again. My rebuild of my evo 6 engine didn't quite goto plan :( so im looking for a new engine to drop in now :) If anyone has one for sale please, would need it delivered to GL2 postcode area. Preferably from an 8? Thank you all in advance.
  15. Wanted
    Hi guys. I am after: bare bottomend+crankshaft+empty head or longblock or complete engine or frontcut or MAYBE damaged/no papers/etc running complete car Have to fullfill the following: EVO5-6-7-8 Standard bore diameter!!! Guaranteed good runner (hearing it running is a good plus point) Good...
  16. Private Sales - Parts
    Currently Breaking Evo 4 Scotia White Location - Maidstone / Kent Contact - Alex 07720 622378 E-Mail - firstIVbits@live.co.uk Drop Me a Text/Call/E-Mail I'll Get Back to You ASAP With Price etc Thanks For Looking
  17. Wanted
    Require full set of valves (plus retainer clips) for Evo 6 CP9A 4G63 Engine. Plus a Valve spring compressor if anyone has one selling cheap?
  18. Private Sales - Parts
    Location - Maidstone, Kent TN12 Contact - Alex 07720 622378 let me know what you require and i will do my best to help Thanks Alex
1-18 of 31 Results
Top