Lancer Register Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-12 of 16 Results
  1. Wanted
    As above, looking for new oil filter housing (filter snapped off). I don't know if I can use a later model Evo housing but if I can and a conversion kit for the banjo fittings exist (i think my evo IV oil lines are smaller than later models), I'm open to that as well.
  2. Private Sales - Parts
    SOLD New, unused, still boxed. Set of 3 gauges, face plate and fitting instructions. The gauges included are boost, voltage and oil pressure Link below to the Rspec page with pictures of the fitted unit etc...
  3. Engine / Turbo
    Hi team I've got a stock Evo 5 engine that had been completely drained dry for over a year. I had put oil down the bores and wound over by hand to keep the bored clean. But this was drained completely before new oil went in. I now have it installed in my car and am ready to start it up BUT...
  4. Technical Questions
    Needing a replacement oil cooler for my Evo 9 Will an oil cooler and pipes from a 7 or 8 fit also ? thanks
  5. Newbie
    Hi guys, sorry for the newbie question! What are the two refill points in the boot of the evo 8? Intercooler spray and the ACD oil? if so, what oil is used? Also, when the car is cold, the oil in the left compartment of the boot reads as "MAX" however once the car is warm, the oil level is...
  6. Engine / Turbo
    Hey folks, Spent the last day searching the forums, but cant seem to find what im looking for, and wondered if you can help / advise me? My Evo 6 TME has a hairline crack in the sump, and i want to replace it with a new sump. Am i right in thinking that you cant get a new sump for a 6, and...
  7. Engine / Turbo
    Ok, here's my guide to removing and refitting the sump/ oil pan after having mine off to [hopefully] rectify an un-identified oil leak. There were a few lessons learnt, such as removing the lower chassis brace(s) to completely remove the downpipe for better access. Parts you will need- grey...
  8. Engine / Turbo
    As the time says looking to get the oil temp gauge hooked up in my car the oil gauge is part of the Mitsubishi triple din gauge set that came in IX 360. I'll need a temp sensor i'm guessing and just some wire, thing is there is 2 wires that come from the gauge for sensors... So does that mean I...
  9. Technical Questions
    Hey evo boys, am about to put a new transfer case in on Wednesday, looking to see what oil a should be using for it, and for topping up the ayc fluid? Cheers boys :smthumbup
  10. Gearbox / Clutch / Transmission
    hi i am recently new to owning an evo so sorry if this has been asked before!!! i am at the moment putting a new paddle clutch into my evo5. i am also having the gearboc reconned because 4th gear was abit pants going in at high rpm,s so i have read a lot of threads on gearbox and transfer box...
  11. Gearbox / Clutch / Transmission
    Is there one?
  12. Technical Questions
    Went to Bedford with Dad on Friday for an evening session. Oil temp was hitting 125-130'C after a few laps (brakes etc still fine as I have big ones) but at that temp I thought I should probably have a cool down lap and come in because I think that's getting towards the limit of what the oil can...
1-12 of 16 Results
Top