Lancer Register Forum banner

Engine block id - rebuild

417 views 0 replies 1 participant last post by  Sparksgsr 
#1 ·
Hi Guys

Having a engine built by a well known tuner next month
going for a forged 2.0lr

I want to get the parts ready to give to him and build
Trouble is the block I have purchased was never fitted to a production car the stamp just has 4g63

I have a head from a 7 and its going in a 6 so 6 wiring loom ecu etc.

Can anybody give me some advise on what to look for I would like a

cam tensioner & roller
crank position sensor (3wire type)?
oil pump
water pump
rear metal water pipe
thermostat housing - can I use the 6 type on a 7 head?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top