Evo 8 JDM Ecu Into Evo 6 Help

[jfed]

Hey - I ended up finding a cheap JDM e8 Ecu that I'm going to put into my 6. I've been trying to match up the pins and everything seems to be ok except for the diagnostic pins from the 6. The 6 has 3 "Diagnostic" pins:

1. 56 - Dignostics (1)
2. 62 - Diagnostics (7)
3. 79 - Diagnostics

The e8 ECU only has:

1. 100 - Diagnostics
2. 85 - OBDII

What do I plug in where? I'm confused as to what I need to do. Any info helps

Thanks

[madmatt]

Out of interest which DIY guide did you follow for the conversion?

[grants]

Not worth the effort, the cost off connectors or a patch lead is £100(ish) to £300+

if you need a later ECU look for Evo7, E8 260 or earlier USDM Evo. Thees will plug in , you'd then have to a few wires around

[jfed]

Originally Posted by madmatt

Out of interest which DIY guide did you follow for the conversion?

No DIY that I could find. I basically just compared the pinout for the 8 with the 6 and am swapping pins

Originally Posted by grants

Not worth the effort, the cost off connectors or a patch lead is £100(ish) to £300+

if you need a later ECU look for Evo7, E8 260 or earlier USDM Evo. Thees will plug in , you'd then have to a few wires around

I got the connectors from a junkyard for cheap (ECU connectors for 1999 USDM Subaru Forester) and bought a used harness extension that I'm going to cut up. It's going to be a lot cheaper than purchasing a USDM E8 ecu ($300+ in Canada)