Mitsubishi Lancer Register Forum - View Single Post - Sealant - manifold Studs
View Single Post
Old 26-03-2020, 23:25   #7
Very Senior User
TrickyDick's Avatar
Join Date: Jul 2006
Location: Surrey
Car: VII FQ-300x2
Posts: 960
Don't think a torque for the stud itself is applicable because there is no "seat" as such so it just needs to be all the way in. The nut defines the torque and will pull the stud out against its treads and sealant etc. You should torque up and then heat up the engine. Once cooled check and re-torque as necessary and it should then be good to go.
TrickyDick is offline   Reply With Quote