Oil pressure logging [Archive] - Mitsubishi Lancer Register Forum

Oil pressure logging

EugeneT5
14-03-2011, 20:59
Is this possible on the standard ECU, and what sensor/gauge combo would I need?

grayw
15-03-2011, 01:54
Yes you can feed an input into the ECU and log it via laptop of OP2 onto SD card. Some people use the input to feed a signal from a MAP sensor or WB into.
Any oil pressure sender with a 0 to 5v output should be compatable.

nousername
17-03-2011, 17:02
Would this be the same for Oil Temp?

wip
19-03-2011, 08:52
Would this be the same for Oil Temp?

Not unless you spend a lot of money on the sensor.

You can do it with a generic temp sensor, but you'll need a pull up resistor.

R-Spec Performance
19-03-2011, 09:38
I believe these are being used on aftermarket ECU's, although not sure on standard.


http://www.rspec.co.uk/index.php?main_page=product_info&cPath=104&products_id=487