Evo IX 3 bar map sensor [Archive] - Mitsubishi Lancer Register Forum

Evo IX 3 bar map sensor

scandinavian fl
01-09-2009, 18:33
Want to fit one of these to a VII anybody know what they cost?

Cheers

Jon

grayw
01-09-2009, 18:42
It's cheaper to buy a complete manifold complete with sensors, than just the MAP sensor from Mitsi:( There was a GB on EvoM for them some while ago, at a good price.

scandinavian fl
01-09-2009, 19:01
Gray I use a GM 3bar on my 8 is there a pin on a 7 ecu I could run the gm to?

grayw
01-09-2009, 19:23
Yes, the one the MDP would otherwise use on the VII.

scandinavian fl
02-09-2009, 12:05
Not sure which one that is I'm looking at the pin connection sheet now? But I think as it's a four plug like the 260 pin 73 is not used . Not sure if this would work mind? When Kob did the how to for the GM sensor he only did for the 8' no 7. :shrug:

grayw
02-09-2009, 17:01
The MDP is listed if you check the wiring diagram:)