HI All
Reading though the instruction and setting up my OS Giken alteration kit, Iv stripped down the cylinder and now setting up the rod put the picture on the instructions isn't the clearest and wondered which side of the nut or washer people set theres at 115mm, Iv attached pics so you can see what I'm on about.
You can see where it tells you to measure in photo 2 but isn't the clearest
Any help would be appreciated or do people set theres up by eye once its all fitted allowing a couple of mm between the release bearing and pressure plate?
Reading though the instruction and setting up my OS Giken alteration kit, Iv stripped down the cylinder and now setting up the rod put the picture on the instructions isn't the clearest and wondered which side of the nut or washer people set theres at 115mm, Iv attached pics so you can see what I'm on about.
You can see where it tells you to measure in photo 2 but isn't the clearest
Any help would be appreciated or do people set theres up by eye once its all fitted allowing a couple of mm between the release bearing and pressure plate?